About Section "Setting Up the Required Peripherals"
- Post By EDGARDO FITA
- 8 months ago
The chapter "configuring the hardware" is quite confusing. At the min 14.30 , it is seen that the cursor moves but the audio dissapears, and suddenly, LWIP middelware is installed but it is not mentioned anytime before.
I've tried to add this but appears a warning when I want to generate code : " - Main Config: These peripherals still have some not configured or wrong parameter values: [LWIP, Verify the Platform Settings Tab ]... Do you still want to generate code ? " .
The configuration part of the ETH module is totally different (already asked by another student).
The issues regarding to USART baud rate are due to the clock value is wrong, the instructor says 25Mhz when is 8. I've set the configuration like that and there were no problems.
Another issue that I've seen is the pin ETH_TX_EN is mapped by default to PB11, but according to user manual , it is connected to PG11, the rest is equal
I can't move on at this moment because LWIP configuration is not explained.
Please check out these issues. The course looks good but is a bit slopy
Ah, and when it want to run the firmware, with a Clean command the old binary (*.elf) is removed