I am using the STM32F767ZI microcontroller and was able to implement a webserver with an HTML/CSS/Javascript formatted webpage that can perform GCI commands and use SSI as well. The issue is that the webpage doesn't stay alive after roughly 30 seconds and after issuing a few CGI commands, the webpage fails to load and the server ultimately stops responding. I tried enabling the LWIP_HTTPD_SUPPORT_11_KEEPALIVE macro in my lwipopts.h file, but no behavioral change. I also tried to up the MEM_ALIGNMENT, MEM_SIZE and PBUF_POOL_SIZE, but still seeing the webpage lose connection over wireshark (see attached). What options do I have and what can l look into to solve the issue? Thanks!

In Programming: Implementing the CDC TX Device, after installing Termite 3.4, I don't understand what is the "USB Serial Device (COM5)" device that you had connected on the Bluetooth & other devices window? Why I did not get it after installing Termite 3.4?

The chapter "configuring the hardware" is quite confusing. At the min 14.30 , it is seen that the cursor moves but the audio dissapears, and suddenly, LWIP middelware is installed but it is not mentioned anytime before.
I've tried to add this but appears a warning when I want to generate code : "  - Main Config: These peripherals still have some not configured or wrong parameter values: [LWIP, V...

Hi,
On tutorial video "Condiguring the hardware" (07:20) a view of ETH configuration screen is different than mine.
As you can see on attached picture there not exist PHY Address parameter.
Parameters only Generals and completely different.
Because that warning about RAM pointing
CubeMX creating
static void MX_ETH_Init function
insted of
static void MX_LWIP_Init function

There is Mode conflict with
PB0 mapped with GPIO_Output

I can't do lesson: "Checking if the cable is connected" because in main.c file not exist function LwIP.

I think I've to set RAM pointing Address for ETH but I don't know how.

What I've to do with that?
How to fix it?

I was taking the Embedded Eth Ess Training with CubeMx course and I have just completed the "Checking if the cable is connected teacher's video". This example is facing the cable connection state. This print a message when cable is connected and disconnected.
Having the ip adress, mask, gateway values initialized, I was expecting to find that nucleo board was able to answer "pings" request to th...